Data not available (100)

Return to Previous Page
''; document.forms['Form0'].method='post'">
Error: Data not available (100)
Error: Data not available (100)
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form3'].method='post'">
Error: Data not available (100)
Replacement Frame Slider
?
Error: Data not available (100)
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form9'].method='post'">
Error: Data not available (100)
Error: Data not available (100)
?
Error: Data not available (100)
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form10'].method='post'">
Error: Data not available (100)
Error: Data not available (100)
?
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form11'].method='post'">
Error: Data not available (100)
Error: Data not available (100)
?
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form12'].method='post'">
Error: Data not available (100)
If you are looking for a
set of frame sliders and
fork sliders for your
BMW S1000RR,
purchase this combo set
and save!
Frame Sliders and Fork Sliders Combo Set
Frame Sliders, Swingarm Spools, and Fork Sliders Combo Set
?
Error: Data not available (100)
Error: Data not available (100)
Data not available (100)

Return to Previous Page
''; document.forms['Form16'].method='post'">
Error: Data not available (100)
This high quality set of OES Frame Sliders fits the
2009-2011 BMW S1000RR. These sliders have high
impact strength and use 6061T6 aluminum inserts which
are pressed in. High strength, rust resistant mounting
screws are included with this set. Absolutely no fairing
modifications are required to install. Complete instructions
are available on this site. This set can be installed in under
ten minutes.

More info on OES Frame Sliders
Our fork sliders for the 09-11 BMW S1000RR will help
protect the forks in the event of a crash. The sliders are
made of Delrin for high impact strength. Supplied with
stainless steel mounting screws. Attached by inserting the
supplied 6061 aluminum rod into the hollow axle and
tightening mounting screws. Installation is very simple and
takes only a few minutes.

-This set does not replace the factory axle.

-The front wheel does not need to be removed to install.

-Medium strength
thread locking compound is highly
recommended for installation of this set.
Our Delrin swingarm spools will fit perfectly on your 09-11
BMW S1000RR. The spools have deep grooves for positive
engagement with your swingarm stand plus they have extra
material on the ends to act as sliders to help protect the
swingarm in a crash. The spools are supplied with mounting
screws.

Scroll down for our combo set of frame sliders and spools.
We offer a combo set of the frame
sliders and swingarm spools as
listed above in a discounted set.
Order here and save!
If a frame slider is damaged in a crash or
by a tip-over, you can replace the side you
need by ordering here.  The new slider is
supplied with the mounting bolt. Side is as
viewed while sitting on the bike.
We also offer a combo set of the
frame sliders, swingarm spools, and
fork sliders as listed above in a
discounted set. Order here and save!
_______________________________________________________________________________________________
_______________________________________________________________________________________________
_______________________________________________________________________________________________
_______________________________________________________________________________________________
_______________________________________________________________________________________________
_______________________________________________________________________________________________